Over
Alle feedback (5.850)
hobby-power (154205)- Feedback gegeven door koper.
Afgelopen maand
Geverifieerde aankoop
Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.
001-supermong (1471)- Feedback gegeven door koper.
Afgelopen maand
Geverifieerde aankoop
Good Buyer. Patient and gentlemen. Fast payment .A
rccontrolfreakuk (20968)- Feedback gegeven door koper.
Afgelopen maand
Geverifieerde aankoop
Thank you for your purchase from rccontrolfreak.co.uk - 1st Class eBayer!
switch_elec (697372)- Feedback gegeven door koper.
Afgelopen 6 maanden
Geverifieerde aankoop
Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.
switch_elec (697372)- Feedback gegeven door koper.
Afgelopen 6 maanden
Geverifieerde aankoop
Hope to deal with you again. Thank you.
phi-sigma-electronics (39449)- Feedback gegeven door koper.
Afgelopen 6 maanden
Geverifieerde aankoop
Good buyer, prompt payment, valued customer, highly recommended.
Recensies (3)
21 nov 2018
interference
I have used these receivers before with no problems but this one caused huge problems applying throttle and steering at random.
07 jun 2016
EAsy build very good
Once you get used to the retaining nuts the build is fairly easy. I wish I had a little more knowledge as it would maybe have helped with some of the placements.
I use mine from the SD card and it is mostly good. The issues I have had were mostly down to me and finding a good replacement for the masking tape supplied. I have been up and printing with great of the bed results, it does what I want so very pleased.
I have two small issues though and I doubt they are limited to this machine! ..and recognising the fact that this is a low cost bare bones machine.
1. Cable routing - it could be more professional particularly the power and drive runs around the frame.
2. Not sure of the value of the filament monitor - on wide parts it seems able to jam the print head and cause positional loss - this is due to the angle from it to the head.
3. Y limit switch - this is on the bed so the cables move and I have broken the joints twice ( before fixing in a better way, I am pretty sure the wires will break after time BUT there are spare in the kit. My prefernce would be to have the switch mounted on the frame so that it cannot move.
4. I would really like to have the power connections fully enclosed and a local on/off switch.
Having said that these are minor problems but would turn a good machine into a fantastic one. I am very happy with the machine and I believe it was good value for money.
It would be great to see some more info on what software to use for design and more background.
11 nov 2020
don't buy
1 van 1 vinden dit nuttig Poor product shown as ceramic , heat resistant and antistatic. They are poor plastic and melt.